1,306
edits
Framing: Difference between revisions
no edit summary
No edit summary |
|||
| Line 1: | Line 1: | ||
===Neutralizing the Intermittent=== | |||
Sometimes called "neutralizing the Geneva" which refers to the internal mechanism. Making sure your intermittent is both centered (we'll go over how to do that in the framing mechanism section) and in a neutral position in relation to the [[Geneva mechanism]] is a must before starting any show. Neutralizing the intermittent must be done before threading a projector EVERY SINGLE TIME no matter what, regardless of whether or not your framing has been re-adjusted. | |||
*To place it in a neutral position, place your fingers on the intermittent sprocket and advance manually. The intermittent sprocket does not rotate continuously, but in steps. Once it's completed a full rotation and stopped, it will be in a neutral position. You should be able to rock the manual advance back and forth a little bit with the intermittent sprocket remaining still. | |||
===The Framing Mechanism=== | ===The Framing Mechanism=== | ||
*From the [[Century]] Projector Manual: "''Rotation of the FRAME knob on the front of the projector causes the intermittent to move up and down. Observe the upper and lower limits of intermittent travel, and position the intermittent at the center of its travel. This will insure adequate movement up or down to correct accidental misframes. Always "center" the intermittent in this manner before threading.''" | *From the [[Century]] Projector Manual: "''Rotation of the FRAME knob on the front of the projector causes the intermittent to move up and down. Observe the upper and lower limits of intermittent travel, and position the intermittent at the center of its travel. This will insure adequate movement up or down to correct accidental misframes. Always "center" the intermittent in this manner before threading.''" | ||