Search results

Cue proximity detectors were programmed to detect [[inboard]] foil cues, [[outboard]] foil cues, and crossframe foil cues. Several manu Consequently, an inboard foil cue could trigger a change-over on one system while triggering an audi ...

...n the film with the frame line on the sprocket, and make sure to place the inboard edge of the film above the post on the roller arm that holds the top of the ...crew has been tightened, remove the machine from the table and tighten the inboard screw. ...

...of the trap, including the lateral guide rollers, taking care to clean the inboard edge of the trap where dirt is hard to see. ...back (lamp side) of the trap. Wipe off any oil that has accumulated on the inboard end. Leave the trap out while you continue cleaning. (Note that when reinst ...

...rollers make contact with the picture area, Kinotons use an O-ring on the inboard (non-soundtrack) film edge to press the film against the drum, reducing the ...

...split reel or shipping reel to a house reel, the film may kiss against the inboard edge. ...

The inboard O-ring on the pinch roller tends to accumulate a lot of dirt. This should b ...