1
edit
| Welcome to Sprocket School! This project is maintained by volunteer editors. Learn more about how this works. |
Main Page: Difference between revisions
Jump to navigation
Jump to search
Just something to start with.
No edit summary |
Filmteknik (talk | contribs) (Just something to start with.) |
||
| Line 19: | Line 19: | ||
4: '''Read further''' on the [http://www.sprocketschool.org/wiki/Resources Resources] page. | 4: '''Read further''' on the [http://www.sprocketschool.org/wiki/Resources Resources] page. | ||
==Kneel Before ZOD== | |||
'''These are some screening room booth policies. It was assumed the reader knew how to do the tasks specified.''' | |||
Check heads and tails of all reels. | |||
Remake any questionable splices. | |||
Remove ALL extraneous tape (masking tape etc.) | |||
Remove any multiple extra frames caused by platter people cutting instead of peeling open an old splice. | |||
Conserve all frames if possible at all. Exception: If it’s just black and silent. | |||
We remove multiple layers of splicing tape. Head leader should be spliced both sides. Tail leaders can be left single sided unless doing so leaves exposed sticky surface then cover it. | |||
ANY SPLICE WHERE YOU CANNOT SEE THE 4-PERF PROGRESSION ON BOTH SIDES MUST BE PULLED THROUGH THE MEASURING DEVICE TO CHECK FRAMING. | |||
Hand scribed dots should be measured on at least a few reels to make sure what standard they are using and whether they are consistent from reel to reel. If not take notes and adjust lace-up of subsequent reels. | |||
Try to avoid making extra dots. For example if C/O dots are too close to end make new ones but then measure the new distance to the motor dots rather than making new motor dots. | |||
The standard I use for new dots is 22 frames to end (including the C/O dot frames) and 10’ 8 frames in between motor and C/O dots EXCLUDING dot frames. Once the C/O dots are made when you measure from before the first C/O dot back to before where the first motor dot will go the counter should be 10’ 12" since the measure will be including the motor dot frames. | |||
INSPECTION SHOULD RESULT IN PRINT ON HOUSE REELS ATTACHED USING SLOTS NOT TAPE. | |||